Board Behind The Gutter

Its top edge is tucked up under the shingles and its outside face is where the gutter is mounted.

Board behind the gutter.

Third it never gets any paint. A rotted fascia board cannot properly support a gutter system designed to withstand the heavy snow accumulations. Then locate the brackets underneath your gutter holding them in place and unscrew them so you can lift the gutter up and away from the fascia. Second it is in an area that is constantly wet or damp.

The soffit board is the piece of timber or pvc that fits to the underside of the rafters closing the gap between the back of the rafter foot and the. The board that rests behind your gutter is called a fascia board. The boards cover the rafter ends and sides at the rakes or. The gutter apron will prevent the dripping.

This can be frustrating and also creates a dangerous situation on porch steps during freez. First since it s always covered by a gutter it is never exposed to sunlight. The fascia is the wide board that s installed on edge and runs horizontally along the edge of the roof. In the end sooner rather than later you will need to replace your gutters once again.

The soffit is the flat panel that covers the underside of the rafters between the back of the fascia and the outside of the house wall. How to replace fascia wood under garage gutters. A gutter apron is a bent piece of flashing that tucks up under the shingles and over the gutter. Facial boards are trim boards that mount to rafter ends underneath a roofs drip edge.

Uninstall the gutter system from the fascia board you re replacing. If water is dripping behind your gutter it s probably because it was installed without any flashing over the back of the gutter. Home centers sell a gutter apron in 10 ft. When fixing gutter brackets to cover boards the screws should go right through the cover board and into the timber board behind it to ensure a sound fixing.

If the decay is already there and you attach a new gutter to the compromised board it will start to fall off very soon. Unscrew the gutters from behind your existing fascia board with an electric screwdriver. However more often than not water does get behind protective metal trim and the wood begins to rot. It lives with some unique problems.